Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
How to test a camshaft sensor of santa fe 2.0 crdi?
06-05-2014, 23:11 PM,
Post: #1
|
|||
|
|||
How to test a camshaft sensor of santa fe 2.0 crdi?
Hi guys, I have an hyundai santa fe 2.0 CRDI and I have ''camshaft position sensor: circuit malfunction''. I changed it with another one but, the same problem is there, please I would like to know how to test it?
|
|||
07-05-2014, 04:58 AM,
Post: #2
|
|||
|
|||
RE: How to test a camshaft sensor of santa fe 2.0 crdi?
Hi mate,
Check the plug and the wires that come from him. Somewhere may be interrupted. There are three wires coming out of it. They are usually pink, gray and black. The pink comes with power from a 10 Amp fuse. The other two go to the ECU. Check fuses 6, 7 or 8 in the engine compartment. ...And be sure and the other sensor is good. If I helped you, please don't forget to press:
.......or this button:................. |
|||
24-05-2014, 12:19 PM,
Post: #3
|
|||
|
|||
How to test a camshaft sensor of santa fe 2.0 crdi?
Oscilogram camshaft and crankshaft only!
Отправлено из моего iPhone используя Tapatalk |
|||
20-01-2016, 08:27 AM,
Post: #4
|
|||
|
|||
RE: How to test a camshaft sensor of santa fe 2.0 crdi?
|
|||
15-10-2017, 14:21 PM,
Post: #5
|
|||
|
|||
RE: How to test a camshaft sensor of santa fe 2.0 crdi?
I don't know about Santa Fe but assume it is similar on all KIA/Hyndai. Best is to find car service manual and there should be diagram showing signals from sensors on oscilloscope. On my car (Rondo, 2.7l, V6) crankshaft sensor produces on/off signal where camshaft sensor produces 'irregular' on/off signal (long on, shorter off and so on). Both sensors have ON and OFF states only as they are of a 'proximity' type and they change state when (usually) metal is close to it (few mm). When engine rotates sensor reads 'cogs' connected to cranksfhat and camshaft. Cranksfaft has regular cogs where one or two are missing and camshaft has a circular plate divided into few segments of different arc. When cranksfahft and camsfaht are in sync (as they always should be) crankshaft off signal shold match with camsfhats one of on signals. Sounds complicated but picture from manual is clear. Also do a search for your vehicle and you can find where sensors are getting signal from. This way you check both sensors outputs and engine sync.
|
|||
15-10-2017, 14:26 PM,
(This post was last modified: 15-10-2017, 14:26 PM by rightpcb.)
Post: #6
|
|||
|
|||
RE: How to test a camshaft sensor of santa fe 2.0 crdi?
I hope he has it fixed now, the original post is more than 3 years old
|
|||
15-10-2017, 17:07 PM,
Post: #7
|
|||
|
|||
RE: How to test a camshaft sensor of santa fe 2.0 crdi?
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content