[raffy haddad]

---

Do you have another tool to read your key ?
Am still with you to the car will start
But give more details why the car not running in the first
Because seems that your file was manupulated
Or by week electricite or by some one
Also can you reread eeprom of immobox and ecu and repost

[tech111]

again new reading

---

again new reading

[raffy haddad]

hello tech111
i am now 100% sure that your key data is in immobox
your new reading is good and there is new things happening in ecu data
so please do the synchro for 45 min now and test
don't forget to connect charger to battery

regards

[tech111]

i did the procedure twice and still not working

[raffy haddad]

did you make diagnostic to see what dtc are in
is battery on car good ?
did you put back all the modules in place ?

regards

[raffy haddad]

did you make diagnostic to see what dtc are in
is battery on car good ?
did you put back all the modules in place ?

regards

here try this method put this file in ecu  eeprom and put back into car
anf follow this
Manual key programming procedure

Key Programming:
When reconnected to the car, the ECU will be in auto-programming mode and will accept new keys as
per the procedure below:
1. Briefly insert any key into ignition lock cylinder and remove immediately. The security light should
illuminate and remain on.
2. Insert the first transponder key into ignition lock cylinder for registration DO NOT TURN ON. The
Security light may blink indicating it has accepted the key. After 3-5 seconds remove the first key from
the ignition. Security light should remain on indicating you're still in programming mode.
3. Insert the second transponder key into ignition lock cylinder for registration DO NOT TURN ON. The
Security light may blink indicating it has accepted the key. After 3-5 seconds remove the second key
from ignition. Security light should remain on indicating you're still in programming mode.
4. Insert third transponder key into ignition lock cylinder for registration DO NOT TURN ON. After
security light goes off remove third key from ignition. The security light should extinguish and then
commence to blink regularly.
5. Wait 30 seconds for the programming cycle and programming mode to close.
The first two keys are internally (inside the ECU) designated as MASTER keys and the 3rd key inserted
will be internally designated as the VALET key.

[tech111]

Again thank you , so I will have to get 3 keys 4D 70 and program to car, since car has only one key

Will try and report back

[raffy haddad]

Better at leasr to have 2 keys your problem is in ecu and not in immobox
If this not work thats 100 %ecu problem
But there is another solution to try it if that also not work

[tech111]

That didnt work also you want me to get another ecu

[raffy haddad]

Hello please do read carfully
Before you buy ecu
Did you make diagnostic on car to find what dtc are in ?
What was the probleme in car in the begining
Because your key data exist in immobox as master key number 1