[Sabreace]

So the hard drive now have installed and starts it. The network cards are all intstalliert and should also fit. Problem now is when ISID started coming in the middle of a message and WSM does not start.

Do you have to write a different MAC address here?
Or because you have to still change what?
I look here by not quite. But perhaps one can tell what still needs to be changed just me.

Thank you for your help.

May you do this ?

[/quote] Ignore Microsoft loopback lan and wifi lan connections.

Your laptop ethernet adaptor is the one that needs to be named Eth0.

then you need to change the ISID mac address to match the mac address of your Ethernet adaptor. Use this procedure:

1. Open a command prompt, type in ipconfig/all and write down the mac address of your Ethernet adaptor.

2. Now change the ISID mac address in the following files, to match the one from step 1 (using notepad or xml editor):

p:\apps\wsm\apps\agent\data\DeviceInventory-ISIDR20000032.xml
p:\apps\wsm\apps\manager\data\DeviceInventory-ISIDR20000032.xml
p:\apps\wsm\apps\manager\data\PXEBootDevices.xml

3. Reboot your computer and after a few minutes ISTA should load up ok (red writing may take a couple of minutes to clear) [/quote]