[TomSab]

hello 
pleas help my in range rover evoque problem 
fault code in ecu engine, abs,suspension and gearbox 
 U0001 high speed comunication Can Bus
sometime ,sporadic

The car is running without any problem some time turn light in dashboard esp
and allroad not found in ecu is this code.

I verification any cable ecu engine,abs,gerbox all O.k. in cable no problem.


thank you a response...

[Viper1989]

Hi, have resolved your problem?
I jave that same problem and additionally I wanted to make update via SDD online and the module has blocked and now I'm stuck. Gearbox, abs,ebd,and light triangle with sterring wheel is blocked. Now not crank.

[TomSab]

not the problem is still!!!
What module has you update?

[Viper1989]

Abs module, in SDD I have choosen "configure abs module" and then car died.
My car was after accident and I found circiut in wire of the parking brake and in speed sensor. I think that in your case problem is speed sensor in some wheel.
After wire repair I have still high canbus problem.
Plug of your main battery and check rezistance in obd socket.
In pins between 3 and 11 must be 60ohm and also 6 and 14 this same.
It will be proof that is all ok with wire of high can in car.
If you get 120ohm thats a circiut somewhere.

[TomSab]

Abs module, in SDD I have choosen "configure abs module" and then car died.
My car was after accident and I found circiut in wire of the parking brake and in speed sensor. I think that in your case problem is speed sensor in some wheel.
After wire repair I have still high canbus problem.
Plug of your main battery and check rezistance in obd socket.
In pins between 3 and 11 must be 60ohm and also 6 and 14 this same.
It will be proof that is all ok with wire of high can in car.
If you get 120ohm thats a circiut somewhere.

my car was also repaired after the accident
and the cables were repaired at the front
and the rear wheel sensors have been replaced
and the problem persists

[Lhcenbolt]

Hello
you have to check the case of Modules in data location after this check the Power and the ground as well ,
i thought the Hs Can Chassis Shorted in somewhere so you have to check the signal via picoscope tool or oscilloscope Then you could be sure if the Network is good without this , you must spend times the cost of repair will be higher withour rescue


Kinds