[AE777]

I retrofitted G11 NBT EVO to my BMW F31 vehicle.

Everything went well but when I VO code the NBT EVO navigation stop working.
It show me information Please use the usb with correct navigation code.

I use the emulator and I didn´t change the VIN
Before VO code I read the FSC status and it shown like below

AppID 288(0x120)
UpgradeIndex 35(0x23)
SWTType SWTclassic light
FSCStatus accepted
FSCCertStatus not available

After VO code when I read the FSC status it show like this

AppID 241(0xF1)
UpgradeIndex 35(0x23)
SWTType SWTclassic light
FSCStatus not available
FSCCertStatus not available

There is no AppID 288 anymore.

But when I changed the HMI_ID_VERSION id4_plus_plus to id5_plus_plus, FSC AppID 288 appeared again but it show FSCStatus not available.

Why the FSC code lost after the VO code?
How I can get it back?

[patriekje92]

Flash it with esys and your vin.
I can send you virgin fsc file and new fsc pack

[AE777]

Flash it with esys and your vin.
I can send you virgin fsc file and new fsc pack

Thanks for your reply.

Are you sure that I have to flash NBTEvo unit?
Everything else works fine except the navigation, because FSC is not available some reason.


Is this possible that I made a mistake to production date changes?
My car is produced 03/13 and I changed built date only 11/13 before VO code.
My car I-Step version is F020-13-03-502

If I flash the NBTEvo head unit with esys and PSdZData 4.13.11 Full and changes unit VIN to my car VIN, can I remove the emulator? Of course then I need the new fake FSC set for my unit?