[som3astar]

Hello mates
I have peugeot partner 2007 edc16c34
Want to read and write with galetto clone v54 china 
I had some problems during the read procedure 
It will not continue to full read the software 
Been told the car goes in eco mode  and need to be disabled 
I have lexia3 and searching to disable it with no success 
Any ideas how to read with galletto obd 
Or to disable the eco mode  ??
So i could read the file and disable the EGR  and write it back 
 
Thank u

[niko]

for this car do it bdm

[som3astar]

for this car do it bdm

Is there any idea how to read it by obd port ?

[fab]

I believe that the car going into bootmode is only a problem when performing operations on the BSI...
You are Reading the ECU... I dont see Any issue there.
Are u sure about the right galletto driver?

[blackTDI]

I believe that the car going into bootmode is only a problem when performing operations on the BSI...
You are Reading the ECU... I dont see Any issue there.
Are u sure about the right galletto driver?

galletto NEEDS to be plugged into 220v to 12v adapter when WRITING, you can read without power supply. you can do it, plug the OBD in, turn on ignition but not start engine, select correct driver then ECU DATA, then read. Recently i had some issues with Gallo v54 clone (good one) there was a "virus" in .dll files, so DISABLE totally your antivirus and be sure that your antivirus dont delete software files. it need to work!!!