[Vojno]

- NCSexper run,
- menü: Datei and choose a profil,
- F1, F3, choose R50,
- than choose EWS or KMB (=KOMBI)
booth modul are store the same configuration and the VIN!
Which is different VIN or config i gave is "bad"
But ISTA-P read KOMBI!

I think in KMB is the config wrong, so choose the EWS first and read it.
If different from what I gave, take a picture of it!

Than you must writ in EWS and KMB the right ZCS back.

[user0086]

@Vojno how did you calculate the ZCS? Is there an easy tool, did you use ZEKO or did you do it manually?

By the way, only check last 7 numbers of VIN, KOMBI in R50 does not store the entire VIN even though NCS Expert might make you think so.

[Vojno]

Fist I calculate with ZEKO, because manually is complicated, at least for me.
But it can be checked from the EWS!

For NCS must specify the whole VIN, independent of KOMBI the use of each module, ex. EWS or CAS!

[Pawel M]

If you can use NCSexper than you need the following ZCS numbers:

GM:  B2310094  and the checksum is: 5
SA:  0000000008103240 and the checksum is:  0
VN:  000000000F and the checksum is:  F

Select the R50 at the beginning then the ZCS and enter the VIN (WMWRC310X0TB87521) check out the checksum checkbox,
enter the GM, SA, VN witout checksum, but check out the checksum checkbox too,
If it is ok, then the same checksum can you see on a gray background!
You must write in ZCS in one of the modules. I don't remember which module stores it, sorry.

Hi, could you help me with ZCS for mini r50
VIN: WMWRC32070TC04158
Thanks

[BMWDriver999]

Hi, could you help me with ZCS for mini r50
VIN: WMWRC32070TC04158
Thanks

GM:  B2321203  and the checksum is: J
SA:  0000000048000040 and the checksum is:  Y
VN:  0000000001 and the checksum is:  4

[Pawel M]

Hi, could you help me with ZCS for mini r50
VIN: WMWRC32070TC04158
Thanks

GM:  B2321203  and the checksum is: J
SA:  0000000048000040 and the checksum is:  Y
VN:  0000000001 and the checksum is:  4

Thanks, unfortunately no luck
I keep getting NO RESPONSE FROM UNIT