[Marines74]

Hi to all. I need DPF off Peugeot 307 2.0HDI engine RHS ecu Bosch EDC15C2
HW 0281010779
SW 1037353725
PLease only tested solutions. Many thanks and regards.

[FlashBack]

here you go.

DPF OFF 

regards

[Strellson]

Full delete DPF, and right CS

[Marines74]

Full delete DPF, and right CS

What about pass Mate?

[Orange_99]

hey buddy,

here your file.

Tell me, perform the file?
Good or bad?

Pass in PM!
Thanks + Reputation!!! 

Thx for your rate!

[Marines74]

hey buddy,

here your file.

Tell me, perform the file?
Good or bad?

Pass in PM!
Thanks + Reputation!!! 

Thx for your rate!

Hi mate. On your file engine does not start and no communication with ECU. Now i have to desolder flash to write other file. Please if you are not sure of your solution do not post it.

[no_name]

hey buddy,

here your file.

Tell me, perform the file?
Good or bad?

Pass in PM!
Thanks + Reputation!!! 

Thx for your rate!

Hi mate. On your file engine does not start and no communication with ECU. Now i have to desolder flash to write other file. Please if you are not sure of your solution do not post it.

Why do you desolder it, when even kess can do it, and galletto, and Ktag also
use this infos

Code:

Connect pin 24 29f400 to GND.
Power ON ECU.
After 3-5 sec disconnect pin 24 from GND.
Connect Galleto socket.
Start Galleto program.
Select AUDI.
In Driver go to bottom and find AUDI WV ME7.x.x 29f400BB PIN 24 FLASH A MASSA
Press ECU DATA button and check answer.
If you see "Boot mode inactive" you have Galleto USB driver trouble. Often this is conflict Galleto USB driver and drivers from other program for virtual USB COM port. Tray to uninstall all other USB COM drivers.
If you see EEPROM ident all OK.
First read flash few time and binary compare files for check connection stability. If OK - you can write.
------------------------------------------------------------------------------------------------------------
Ok if that helps someone.....Today i did boot mode with ECU on the car and it works.Car is Peugeot 406 Coupe 2.2HDi 2004 year EDC15C2
1.I removed the battery negative.
2.Turned ignition ON.
3.Conected MPPS to car EOBD and started the software.
4.Then opened the ECU casing.
5.After that conected the boot pin to 29F400 and my friend conected the negative terminal.I waited 5 second with boot cable ( 5kOm ) then removed boot cable.
6.Choosed in MPPS General - Me7.XXX writing ok.All was fine.Tried this procedure for reading and was fine ,too.
I hope this helps someone  :)
------------------------------------------------------------------------------------------------------------