[keyzex]

I bought the car as a non-starter, but as it is CAN I gave up immo off and parked it until today.

Too much spare time made me disassemble UCH and read 93C66 /16bit today.

Then I see that VIN is completely wrong, and my brain.exe gave syntax error when trying change to the right VIN in hexedit.

So now I need your help to change it to VF1CB0FCF25871235

Facts:
Renault Clio 1.2
Year 2002
ECU S110115000 A / 8200162378
Chip 29F200BB
CANbus immo VERLOG 3

Thanks in advance

uch_16.rar
File Type:
Downloaded:	18 times
Size:	298 bytes

uch_8bit.rar
File Type:
Downloaded:	11 times
Size:	297 bytes

UCH



Extractor


HEX

[pillsburry]

hi mate looking a pic of dump the vin from the extractor is in ascil 2 times have you tried just editing the bin and programing it back in to eeprom mate

[keyzex]

hi mate looking a pic of dump the vin from the extractor is in ascil 2 times have you tried just editing the bin and programing it back in to eeprom mate

Yes I have tried to write myself but it just goes wrong, I do not know if vin is in swap format in eeprom.

I have worn my hair all day, so I don't have to go to the hairdresser for a long time

[pillsburry]

hi mate had think about this one for a few mins take a look at this file in RenaultPinExtractor


hope this help i new to the Renault immo scean so its my first try take a look mate

[keyzex]

hi mate had think about this one for a few mins take a look at this file in RenaultPinExtractor


hope this help i new to the Renault immo scean so its my first try take a look mate

Thank you very much, it looks quite right.
Do you know if it should be written in 8 or 16 bits.
I'll report the results tomorrow.
Did you use brain.exe?

[pillsburry]

id say how ever you read it wright it the same
like i said new to renualt im more VAG opel/vox and so on but i try to help when others need help i no expert but try mate

ive also run the file i maid though zedbull and it say valid immo file so all shuld be good mate i also sent you a buddy req i like to help out and network mate

[keyzex]

id say how ever you read it wright it the same
like i said new to renualt im more VAG opel/vox and so on but i try to help when others need help i no expert but try mate

ive also run the file i maid though zedbull and it say valid immo file so all shuld be good mate i also sent you a buddy req i like to help out and network mate

The same here VAG is my area where I am fully equipped with tools and good knowledge, I have accepted buddy request

[keyzex]

I have tried the dump file, the immo lamp still flashes.

But if I program the key with Carprog then Carprog shows the right vin and pin code, the lamp stops flashing.
But when I turn off the ignition to start and turn to start immo is active again.

The antenna ring is whole I have changed it.

Someone who has a clue?

[flavio69]

Hi.....because I am a lazy person,I always choose the short version,I'm using Renolink,it;s a 1 minute of work.cheers mate...

[raffy haddad]

hello
did you precode the transponder ?
regards