[Znuff]

hey, I would like to flash ecu with ista. I have original ICOM.
My question is:
Should I use
1) Dealer organisation ICOM/ENET Local area network
or
2) Dealer organisation ICOM/ENET direct connection
?

What are differences beetween those two options?

Should I change something in  Edabias.ini?
Current now I have
Interface = REMOTE

ICOM doesn't use ediabas.in;

For stand-alone operation "Direct Connection" is fine.

My setup: Apple MacBook Pro 15" 2017 running Windows 10 via BootCamp.

I downloaded and installed ISTA 4.32.15 without any issues. UI font size is perfect but the font size of the documents is too small (see attachments). I tried to play with Width and Height properties in ISTAGUI.exe.config, tried smaller and bigger than the default ones but didn't notice any difference at all. I managed it by changing the system resolution to 1680x1050 and scaling to 100% but then Windows looks ugly. Is there a better solution?

P.S. I may apologize for asking questions about such an old version of ISTA but I am new to the forum, so I can't request a license yet.

Check if you have Display Scaling enabled in Windows 10. If you do, set it back to 100%