[dmbfan17]

Hello all, I’ve never had an issue programming or coding before. A friend asked me to look at his F80 after it came out of the shop. Cluster wasn’t working and it was driving like poo. So I fired up Ista+ 4.32.15 and started programming. All was perfect for over an hour, then all of the sudden I started getting No Net communication errors and to shut off ignition and buckle seat belt prompts, which no matter what wouldn’t clear. Ultimately the last 25% or so of programming failed. After this nothing would work properly again. No Net and ignition errors are persistent. I decided to switch to enet..nothing recognized enet now even though it worked previously on my F25. I’m at a loss here, I’ve uninstalled everything, cleared registry, updated firmware on icom, tried changing ip on icom etc..any insight will be greatly appreciated.

Thanks in advance!

Tom

Maybe stupid question but have you used an battery charger with supply mode while working with the car?
Sounds to me that possibly the battery of the car broke down a bit.

Not at all a stupid question, I did use a charger and never saw the car drop below 13.8..now that’s not saying it’s couldn’t have dropped for a minute and I didn’t notice it..worth another attempt with precharging as well before trying to finish. Thanks for the response!