[Kinder]

c-max 2013 usa hybrid start stop, seems like key should be 4d6f + remote with nxp on pcb, bcm 95320, tango recognize, writes transponder, car starts, but remote/keyless learn not successfull, what procedure or corect remote should be?

[flamuri]

2010-

1. Insert the first previously programmed coded key into the ignition.
   
2. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.
   
3. Switch the ignition off and remove the first coded key from the ignition.
   
4. After three seconds but within 10seconds of switching the ignition off, insert the second previously coded key into the ignition.
   
5. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.
   
6. Switch the ignition off and remove the second previously programmed coded key from the ignition.
   
7. After three seconds but within 10 seconds of switching the ignition off and removing the previously programmed coded key, insert the new unprogrammed key into the ignition.
   
8. Switch the ignition from off to on. Keep the ignition on for at least six seconds.
   
9. Remove the newly programmed coded key from the ignition.
   

[size=undefined]
If the key has been successfully programmed it will start your vehicle and operate the remote entry system (if the new key is an integrated keyhead transmitter).
If programming was not successful, wait 10 seconds and repeat Steps 1 through 8. If you are still unsuccessful, take your vehicle to your authorized dealer.
[/size]

[Kinder]

you sure this procedure for keyless system?
and strange need have 2 coded and 1 unprogrammed, so 3 keys?

[Kinder]

CJ5T-15K601-DX used original keys can be relearing to another car? after learning are locked?
procedure is just to push unlock button for 1 sec