[abbate22]

Hi, I have a problem with the Continental Airbag control unit 51918197 error code B0101 - Control unit power supply, I checked the correct power supply, checked the resistance of all the installed airbags, the spiral duct of the light switch is good and thanks to the AL70 user I proceeded to clean the eprom 95320, but the problem remains. I tried to replace the continental control unit with the code 51897787, it is recognized by the body but it does not allow me to configure it with MES and it gives me the following error in the proxy alignment it tells me: Air Bag node (NAB / ORC) FAILED! - Request error out of range (with relative odometer flashing), what advice to solve?

[canisha]

TO BUY A CONTROL UNIT WITH THE SAME NUMBER

[Tracshan]

Hi, I have a problem with the Continental Airbag control unit 51918197 error code B0101 - Control unit power supply, I checked the correct power supply, checked the resistance of all the installed airbags, the spiral duct of the light switch is good and thanks to the AL70 user I proceeded to clean the eprom 95320, but the problem remains. I tried to replace the continental control unit with the code 51897787, it is recognized by the body but it does not allow me to configure it with MES and it gives me the following error in the proxy alignment it tells me: Air Bag node (NAB / ORC) FAILED! - Request error out of range (with relative odometer flashing), what advice to solve?

You mentioned that "the spiral duct of the light switch is good" i assume you are referring to the clock-spring, correct? if yes, how exactly did you reach the conclusion that this is good?

[abbate22]

yes! I did the test by replacing the light switch with an identical one to be sure that it is not the spiral spring.

---

before buying a new airbag control unit, would there be the possibility of repairing the one already inserted? I have known that the seat belt and passenger airbag sensors work, the code b0101 refers to an internal problem of the same