Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
27-03-2019, 23:24 PM,
Post: #1
|
|||
|
|||
UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
Hi,
I have problem with reading immo module from Opel Vectra B 1999 year with Motorola MC68HC05B6 0F10V. I am using orginal UPA-S Programmer and special orginal adapter for it - UPA HC05 HC705 (bought in Tomsad site photo in attached.) After I desolder Motorola from board and put it into HC05 adapter in UPA connections test I have TxD in red colour with value 0,02V (all other connections are green). After this when I am trying to read this Motorola I get in Upa message - Frame error. I was trying to change the voltage and oscillator values. Am I doing somethink bad? or it is not my fault. Please help. Photos from reading in attached Thanks |
|||
28-03-2019, 00:35 AM,
Post: #2
|
|||
|
|||
RE: UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
seems adapter faully
By the way is not needed to unsolder the mcu from board , solder all wires as in UPA manual and cut two bridge i did few of them and went smoothly Good luck BEST CHIPTUNING SERVICE BY Zenter Performance
Contact Skype: zenter-88 Facebook: https://www.facebook.com/ZenterPerformance -------------------------------------------------------------------------------------------------------------- highest Quality ChiPTuninG Files BY PTF Team https://performance-tuningfiles.com/ POWER BY TECHNOLOGY -------------------------------------------------------------------------------------------------------------- BEST CHIPTUNING SERVICE BY Jurebv Contact Skype: live:jure.coric_1 https://files.tuning-makarska.com/ -------------------------------------------------------------------------------------------------------------- - IMMO/ECU , ODO , AIRBAG , CARRADIO , TESTED SOLUTIONS UNDER MY SOFTWARE In progress TUNING STAGE1/DPF/SCR/EGR/TVA/FLAP/ START STOP OFF Software WHAT'S NEWS ! -Steering Angle Sensor Restore For LEXUS,TOYOTA,SUBARU,MITSUBISHI,VAG -Citroen DS5 Steering lock Renew/Write Code by dumps -Passat CCM Repair corrupted dump succes -VAG ECU SIMOS PCR 2.1 KM WITH CRC CORRECTED ! -IMMO OFF For NISSAN/INIFINITI with HITACHI ECU | CPU SH705X -Dacia Dashboard with Fujitsu MB96F6A6 Change km/Block Synchro Dash-ABS -=[Full WinOLS/ECM Titanium User] =- Remember! dirty hands are a sign of clean money шшш.αήkαbôôτ.Ćô.цk |
|||
28-03-2019, 06:08 AM,
Post: #3
|
|||
|
|||
RE: UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
can you explain wit the bridge (some photos or other pdf)
|
|||
28-03-2019, 12:00 PM,
(This post was last modified: 28-03-2019, 12:00 PM by dil6222.)
Post: #4
|
|||
|
|||
RE: UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
Easiest way if you have already desolder it connect with normal upa pinout then add a 8mhz crystal between osc1osc2 works 100 % I've tested on many hco5b6
If mine or others posts and info are helpful please give thanks/rep
|
|||
11-04-2019, 23:26 PM,
Post: #5
|
|||
|
|||
RE: UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
(28-03-2019, 06:08 AM)kobi2311 Wrote: can you explain wit the bridge (some photos or other pdf) maybe late but here the pinout for read in circuit Good luck BEST CHIPTUNING SERVICE BY Zenter Performance
Contact Skype: zenter-88 Facebook: https://www.facebook.com/ZenterPerformance -------------------------------------------------------------------------------------------------------------- highest Quality ChiPTuninG Files BY PTF Team https://performance-tuningfiles.com/ POWER BY TECHNOLOGY -------------------------------------------------------------------------------------------------------------- BEST CHIPTUNING SERVICE BY Jurebv Contact Skype: live:jure.coric_1 https://files.tuning-makarska.com/ -------------------------------------------------------------------------------------------------------------- - IMMO/ECU , ODO , AIRBAG , CARRADIO , TESTED SOLUTIONS UNDER MY SOFTWARE In progress TUNING STAGE1/DPF/SCR/EGR/TVA/FLAP/ START STOP OFF Software WHAT'S NEWS ! -Steering Angle Sensor Restore For LEXUS,TOYOTA,SUBARU,MITSUBISHI,VAG -Citroen DS5 Steering lock Renew/Write Code by dumps -Passat CCM Repair corrupted dump succes -VAG ECU SIMOS PCR 2.1 KM WITH CRC CORRECTED ! -IMMO OFF For NISSAN/INIFINITI with HITACHI ECU | CPU SH705X -Dacia Dashboard with Fujitsu MB96F6A6 Change km/Block Synchro Dash-ABS -=[Full WinOLS/ECM Titanium User] =- Remember! dirty hands are a sign of clean money шшш.αήkαbôôτ.Ćô.цk |
|||
12-04-2019, 10:31 AM,
(This post was last modified: 12-04-2019, 10:33 AM by dil6222.)
Post: #6
|
|||
|
|||
RE: UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
(11-04-2019, 23:26 PM)volavka Wrote:(28-03-2019, 06:08 AM)kobi2311 Wrote: can you explain wit the bridge (some photos or other pdf) That's the way I used to do it there's also the pin lift way but it's harder. its much easier to desolder and read in a socket plus there is no trace/bridge cutting so no damage to board If mine or others posts and info are helpful please give thanks/rep
|
|||
12-04-2019, 13:53 PM,
(This post was last modified: 12-04-2019, 13:54 PM by rch11.)
Post: #7
|
|||
|
|||
RE: UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
This is. It is faster to desolder and solder the MCU.
If I helped,do not forget to press the &
|
|||
12-04-2019, 15:36 PM,
Post: #8
|
|||
|
|||
RE: UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
|
|||
13-04-2019, 17:59 PM,
(This post was last modified: 13-04-2019, 18:03 PM by dil6222.)
Post: #9
|
|||
|
|||
RE: UPA-S USB Problem with reading Motorola MC68HC05B6 0F10V Immo Opel Vectra
(12-04-2019, 15:36 PM)zmann Wrote:(28-03-2019, 12:00 PM)dil6222 Wrote: Easiest way if you have already desolder it connect with normal upa pinout then add a 8mhz crystal between osc1osc2 works 100 % I've tested on many hco5b6 Hello zmann yes crystal already on his adapter next thing will be to check adapter and yes why do ask ? If mine or others posts and info are helpful please give thanks/rep
|
|||
« Next Oldest | Next Newest »
|
Possibly Related Threads… | |||||
Thread | Author | Replies | Views | Last Post | |
VL300 immo transfer | mecatech | 5 | 179 |
3 hours ago Last Post: sixcode |
|
Piaggio Porter Bosch M7.8.0 M78 Immo Off | Kayhan 17# | 0 | 12 |
8 hours ago Last Post: Kayhan 17# |
|
IMMO off Renault Kangoo | johann74270 | 2 | 45 |
Yesterday, 20:24 PM Last Post: johann74270 |
|
immo off bosch edc15vm+ audi a6 | tintoverano | 3 | 37 |
Yesterday, 18:38 PM Last Post: sokisoki3 |
|
IAW4HV.AS IMMO OFF | BORUCU | 1 | 24 |
Yesterday, 18:19 PM Last Post: Mrpromega |
|
No Feedback Given MITSUBISHI L200 E6T01476 IMMO OFF | crisvenua2 | 3 | 246 |
Yesterday, 14:49 PM Last Post: raffy haddad |
|
IMMO OFF PSA SID 807EVO | GTR35 | 4 | 112 |
Yesterday, 13:59 PM Last Post: k.elmajdouby |
|
Mitsubishi Pajero E6TO immo off | johann74270 | 2 | 51 |
Yesterday, 12:30 PM Last Post: johann74270 |
|
Solved ✔ VW Lupo 1.4FSI MED7.5.10 immo off | vwdamian | 2 | 33 |
Yesterday, 08:42 AM Last Post: vwdamian |
|
VW MED17.5 BAD IMMO OFF | victorysatgr | 6 | 65 |
Yesterday, 08:03 AM Last Post: ROD-BENDERS |
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content