Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
fiat scudo 2014 bsi johnson control BSI ERROR
08-04-2019, 08:27 AM,
(This post was last modified: 09-04-2019, 12:43 PM by doditnt.)
Post: #1
|
|||
|
|||
fiat scudo 2014 bsi johnson control BSI ERROR
Hello.
i have FIAT SCUDO YEAR 2014 with PSA system. i have do kilometers with x-tool. First on BSI with x-tool and after on dash with eprom programmer. now chilometers are ok, i have try to drive and connect/disconnect battery. all ok, but only a problem: when i connect a disgnostic tools, it doesn't find any system. not read vin number and not find other system then motor. but with x-tool, it show me correct vin. i enter with launch diagnostic tools, in citroen, jumpy 2014 i found error in bsi, error 0303 fault telecodify the most serious problem is that when I close the car with the remote control, it closes correctly, but after a while the alarm goes ON and alarm sound go !! 'I have to insert the ignition key and turn it on to power off the alarm. i have tried to reset bsi but without result. Please help |
|||
08-04-2019, 10:43 AM,
(This post was last modified: 08-04-2019, 10:58 AM by otojm.)
Post: #2
|
|||
|
|||
RE: fiat scudo 2014 bsi johnson control problem after km
(08-04-2019, 08:27 AM)doditnt Wrote: Hello.hi, i think you have alter the flash-dump in the bsi ? you must find an original & exact dump for your bsi, and reflash it with adequate tool (AVDI for example)!!! or look if x-tool save the dump automaticly |
|||
08-04-2019, 12:56 PM,
Post: #3
|
|||
|
|||
RE: fiat scudo 2014 bsi johnson control problem after km
(08-04-2019, 10:43 AM)otojm Wrote:(08-04-2019, 08:27 AM)doditnt Wrote: Hello.hi, i think you have alter the flash-dump in the bsi ? you must find an original & exact dump for your bsi, and reflash it with adequate tool (AVDI for example)!!! I HAVE already REFLASHED WITH ORIGINAL FILES, SAVED IN BACKUP FOLDER OF X-TOOL |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content