[doditnt]

Hello.
i have FIAT SCUDO YEAR 2014 with PSA system.
i have do kilometers with x-tool. First on BSI with x-tool and after on dash with eprom programmer.
now chilometers are ok, i have try to drive and connect/disconnect battery.

all ok, but only a problem: when i connect a disgnostic tools, it doesn't find any system.
not read vin number and not find other system then motor.
but with x-tool, it show me correct vin.
i enter with launch diagnostic tools, in citroen, jumpy 2014

i found error in bsi, error 0303 fault telecodify

the most serious problem is that when I close the car with the remote control, it closes correctly, but after a while the alarm goes ON and alarm sound go !!

 'I have to insert the ignition key and turn it on to power off the  alarm.

i have tried to reset bsi but without result.

Please help

[otojm]

Hello.
i have FIAT SCUDO YEAR 2014 with PSA system.
i have do kilometers with x-tool. First on BSI with x-tool and after on dash with eprom programmer.
now chilometers are ok, i have try to drive and connect/disconnect battery.
all ok, but only a problem: when i connect a disgnostic tools, it doesn't find any system.
not read vin number and not find other system then motor.
but with x-tool, it show me correct vin.

the most serious problem is that when I close the car with the remote control, it closes correctly, but after a while the alarm goes off and the remote control 
does not work anymore 'I have to insert the ignition key and turn it off.
What do you think ? can you help me ?
Thanks a lot.

hi, i think you have alter the flash-dump in the bsi ? you must find an original & exact dump for your bsi, and reflash it with adequate tool (AVDI for example)!!!
or look if x-tool save the dump automaticly

[doditnt]

Hello.
i have FIAT SCUDO YEAR 2014 with PSA system.
i have do kilometers with x-tool. First on BSI with x-tool and after on dash with eprom programmer.
now chilometers are ok, i have try to drive and connect/disconnect battery.
all ok, but only a problem: when i connect a disgnostic tools, it doesn't find any system.
not read vin number and not find other system then motor.
but with x-tool, it show me correct vin.

the most serious problem is that when I close the car with the remote control, it closes correctly, but after a while the alarm goes off and the remote control 
does not work anymore 'I have to insert the ignition key and turn it off.
What do you think ? can you help me ?
Thanks a lot.

hi, i think you have alter the flash-dump in the bsi ? you must find an original & exact dump for your bsi, and reflash it with adequate tool (AVDI for example)!!!
or look if x-tool save the  dump automaticly

I HAVE already REFLASHED WITH ORIGINAL FILES, SAVED IN BACKUP FOLDER OF X-TOOL