Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
How to get current steering wheel sensor position value with ISTAD
12-04-2019, 17:21 PM,
Post: #1
|
|||
|
|||
How to get current steering wheel sensor position value with ISTAD
Hi. I have a BMW G30 2017. After several wheels alignments, I think my car thinks the steering wheel straight is not at the same position as it was actually set to be during the wheels alignment process. I am not planning to do a reset now, just want to see where my car thinks the "Zero" position is (meaning straight).
I can connect to the car with Rheingold, read fault codes (which I almost have none, luckily), but from there I don't know where to proceed to get the steering wheel position reading. Could someone give a general description of what to do to get to the readings? I get that there are such concepts as test plan, several ways to run routine procedures, so a normal BMW ISTAD language would be fine, I'll figure it out. Thanks in advance. |
|||
12-04-2019, 18:37 PM,
Post: #2
|
|||
|
|||
RE: How to get current steering wheel sensor position value with ISTAD
In the module tree, click the power steering module and call up ecu functions. There's a tab in there that allows you to view live data.
Here's a little trick I learned with steering angle calibration. View the backup cam lines relative to the angle of your steering wheel. It's possible to have the wheel off by 360 degrees. The backup cam will show you |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content