[youbarajs]

I am quite out of option to figure out what else is required to enable the Voice Command in my 2011 E90 to work for all controls like CD/Multimedia, Radio, Navigation etc.

I have patched the CIC with all necessary certificates and FSC are accepted (17,1B) Navigation works well, but by Voice Command only works for Telephone Menu (Dial Name, Dial Number, Save Name, Phonebook etc), but when I pass on the commands for other functions like Navigation or Map or even CD, it keep asking me to repeat the command.

I have added $620 (Voice Control) to VO, SGReset whole car etc. but it is still not working.

Even before adding $620 (and FSC Patch for 0017) my Voice Command use to work for Telephone Menu (I had initially added $644-PREPARATION F MOBILE PHONE W BLUETOOTH before the CIC Patch, which is still there in VO)

As per the Manual when I select a particular Menu (say CD/Multimedia in Idrive) and speak "Voice Commands" it is supposed to give me all options for that particular menu, but when I try this either it says "this command is not available" or "it starts re-dialing number (first one in the Redial list)

I have CIC.C1A, on an E90 with MULF2HI SVS on trunk. The only option I have in NCSExpert for CIC is SVS (Voice Recognition), but when I set this to "aktiv" even the telephone command stops working.

CIC Version in Idrive is CIC_L6_1107_Release_B1107-501-1121A Build 11(2011-05-20)

[youbarajs]

Don't know why but the moment I post a question in this forum, I find an answer to the problem myself. Solved this by SG_CODERIN a blank .man to CIC module. Voice Commands are active and gosh this female voice sounds much better than that grumpy old dad.
Lesson learnt, SG_RESET is not same as SG_CODERIN with blank .MAN in expert mode..