[dada]

Hi

I need help. TRW 89170-02J40 Toyota Auris

95160. Thanks for the help.

[volavka]

Here your File 

Pass in PM

[superjet]

Try and report back.

[dada]

Hi, a car will be available tomorrow. However, there are quite a difference in those binary files i.e. between volavka and superjet. Will let you know regarding the results. Cheers

[dada]

The errors on both eproms are deleting themselves. A driver's air bag error still remains - B1802
Fitting of 2.2 ohm resistor does not help either. Didn't the airbag controller endure airbag detonation?
Any suggestions? Cheers

[superjet]

B1802 mean short circuit to ground,you need check the wire ,do you disconnected the wire from the airbag module and check it report open circuit failure DTC?

[dada]

There is a constant error B1802 either on connected or disconnected airbag. Wires checked. Resistor simulation does not bring any effect. It seems like a controller failed, however I might be wrong.

[superjet]

B1802 Short in D squib circuit (to ground),you need clear DTC and disconnected the Spiralcable and read DTC,if change to B1801, means the Spiralcable not plug enough,reinsert.if not change ,disconnect the SRS module side pin to check the DTC,if change means the circuit short to ground.