[left1980]

Hello guys!

I m new to eeproms flashing. I want to change a CAS2 from E60  61356965050  5wk 7995   with a used one.
If i read from my CAS the internal eeprom of mc9s12dg with xprog , then read and erase  donors eeprom and  write with my CAS file,  will the car start? And allign ews/dme of course.

Thanks in advance

[rs@chip]

Hello guys!

I m new to eeproms flashing. I want to change a CAS2 from E60  61356965050  5wk 7995   with a used one.
If i read from my CAS the internal eeprom of mc9s12dg with xprog , then read and erase  donors eeprom and  write with my CAS file,  will the car start? And allign ews/dme of course.

Thanks in advance

yes.. swap eeprom and flash/update cas with corect ZB number would be best way, ofcourse you can swap flash too but depend of what s wrong with your old one (corupted or not) thats why flash by winkfp ot ista-p is always better

[left1980]

You mean swap eeprom physically desolder and solder or swap files? Old cas has water damage, will not switch kl15.

[rs@chip]

You mean swap eeprom physically desolder and solder or swap files? Old cas has water damage, will not switch kl15.

no mate swap eeprom data only..than finish the yob with winkfp or ista-p

[left1980]

ok, understand, thanks!

i ll give a try and post results