[grisu-en]

we have an Iveco Crossway EEV with Cursor Motor
we had to Change the Denoxtronic (Bosch)but now we have the Problem to put Data on it.
Is There a solution to read data from the old/or anoter Module? and what do we Need to do this?
second Question is how we can erase Long term Errors in Denoxtronic , there must be a solution because a Technician from FPT made this in another car (Hess Swisshybrid) also with Bosch Denoxtronic.
we have original easy from Iveco .
can anyone help me?

[Trebor]

we have an Iveco Crossway EEV with Cursor Motor
we had to Change the Denoxtronic (Bosch)but now we have the Problem to put Data on it.
Is There a solution to read data from the old/or anoter Module? and what do we Need to do this?
second Question is how we can erase Long term Errors in Denoxtronic , there must be a solution because a Technician from FPT made this in another car (Hess Swisshybrid) also with Bosch Denoxtronic.
we have original easy from Iveco .
can anyone help me?

hello you have to use the EASY teleservices to replace the denox leaving the old denox connected and then when the on-screen instructions tell you to replace the old one with new one you do it without disconnecting power and batteries and so with new denox long-term failures will also disappear

[Roby]

you need the original tool iveco EASY... and the long error term
they do not cause problems even if they remain in the denox fault memory..