[Manny786]

Needed to replace DDE 
Got a used module, read old module with Ktag - checksum error after full read, file size 712 kB, engine not starting and
diagnosis not showing dde. Probably had insufficient contact with the pads.


edc16c35
hw 0281012707
sw 1037397658
sw upg 07809540

original ecu had water damage I have read full bdm I used ktag on to used ecu the cu don't communicate and when I read or write with k tag it says check sum error

I need hel either repair this or full virgin bdm

[giiintas]

Needed to replace DDE 
Got a used module, read old module with Ktag - checksum error after full read, file size 712 kB, engine not starting and
diagnosis not showing dde. Probably had insufficient contact with the pads.


edc16c35
hw 0281012707
sw 1037397658
sw upg 07809540

original ecu had water damage I have read full bdm I used ktag on to used ecu the cu don't communicate and when I read or write with k tag it says check sum error

I need hel either repair this or full virgin bdm

try swap eprom over with old ecu 

[Manny786]

Needed to replace DDE 
Got a used module, read old module with Ktag - checksum error after full read, file size 712 kB, engine not starting and
diagnosis not showing dde. Probably had insufficient contact with the pads.


edc16c35
hw 0281012707
sw 1037397658
sw upg 07809540

original ecu had water damage I have read full bdm I used ktag on to used ecu the cu don't communicate and when I read or write with k tag it says check sum error

I need hel either repair this or full virgin bdm

try swap eprom over with old ecu 

hi I have tried still no communication with ecu I need help urgent thanks its the flash also faulty