[radevv]

Hello all, 
I was reprogramming CAS on R56 Mini with ISTA-P v.3.58.0.500 using K+DCAN cable. I got a report stating fault code with "Global Vehicle Communication CoAPI.7056"

At the moment CAS is not working and ista-p doesn't recognize car. When a manually input VIN it is asking for VO. I got a xml VO file from a member here but upon importing the file to ista-p I receive an error that VO is invalid.

I would like to try with another VO file if someone can provide that


Any help is greatly appreciated!!!   


WMWMF335X9TU75382


Thank you!

[EngineGeneration]

WinKFP and not key in engine position

[radevv]

WinKFP and not key in engine position

Thank you for your reply! The problem is that I'm fairly new to coding and I have never done anything with winkfp. Where can I find information what I need to do?

[Semi14]

You can find everything on the internet. Download Sp-daten to the car you need. The operation is quite simple. You should handle it. Cas is programmed without a key

[Matthew53]

I always mention, that it's not recommended to programm with K+DCAN, but if you started, then try to finish it. In this case, I would advice to use expert mode of WinKFP. In attachment, you have a manual.
Take the v66 SP-daten. 
Check the newest ZB in WinKFP comfort mode and then use the same for expert mode.
When the operation complete, use NCSExpert to read VO from FRM and write into CAS [Job name: FA_write]. Then code CAS to the default.