[salaausi]

hi all,

I need a dash dump for Mitsubishi Lancer 2000, Yazaki odo

Odo chip - AD09952G

no idea which type need to select on digiprog 3, I tried 93c56, and 93c86 on digiprog 3. But not reading correct mileage. 

Could someone please share a dump with 170,xxxkm for me.

Cheers!

[Clusters]

That dash should have 93c46 and you should unsolder it.

[salaausi]

That dash should have 93c46 and you should unsolder it.

do you have any dump for this dash?

[Clusters]

You can try this dump.....

Flip the board over and see if Pin 3 & Pin 4 are joined, if they are cut the trace then resolder after programming.

[salaausi]

You can try this dump.....

Flip the board over and see if Pin 3 & Pin 4 are joined, if they are cut the trace then resolder after programming.

yes pin 3&4 are joined. 

so no need to pull the chip out from the board? or short the crystal oscillator 2 pins?

or just straight solder the pins from the programmer.

Cheers!  I will let you know the result soon.

[Clusters]

Safer to unsolder it, then read as 93c46 and save a copy. Then post the original file here.

[salaausi]

Safer to unsolder it, then read as 93c46 and save a copy.  Then post the original file here.

please check the file. I'm not sure whether this file read well or not.

[Clusters]

Mostly read well, with one odd byte but that happens

337448 Km

Here is your file modified

[salaausi]

Mostly read well, with one odd byte but that happens

337448 Km

Here is your file modified

Thanks Mr.Clusters. I will let you know the result.

---

Mostly read well, with one odd byte but that happens

337448 Km

Here is your file modified

worked well. thanks again.