[aknight720]

Maybe IToolRadar is not designed for ICOMP? I see port 6801 open so you should be able to connect to a car. All configurations ports seem to be closed which might be expected from the factory tool.

I would doubt such as IToolRadar would work because the nvm port 5302 was not on the scanner list.

[Node]

Given vnm is not available the only way I see to use this with ISTA+ is through Ediabas in remote mode.

[emaflo1978]

any idea how can I connect to car, which settings ISTA VCI Configuration Manager?

thanks

[Node]

Choose ediabas there. And configure ediabas in remote mode using IP address of your device.

[emaflo1978]

 How can I configure ediabas in remote mode using IP address?

it`s ok?

Thanks

[Vojno]

INTERFACE = REMOTE

the interface=std:obd line must be starts with ";"

[Matthew53]

INTERFACE = REMOTE  

the interface=std:obd line must be starts with ";"

It doesn't has to start with ";". There is only a # there and it's enough.

[Vojno]

INTERFACE = REMOTE  

the interface=std:obd line must be starts with ";"

It doesn't has to start with ";". There is only a # there and it's enough.

Yes!
I mean this is the good:

; INTERFACE     =STD:OBD

INTERFACE       =REMOTE

[Matthew53]

INTERFACE = REMOTE  

the interface=std:obd line must be starts with ";"

It doesn't has to start with ";". There is only a # there and it's enough.

Yes!
I mean this is the good:

; INTERFACE     =STD:OBD

INTERFACE       =REMOTE

Maybe it's correct too, but it's always set as default like this:

Interface        = REMOTE

#Interface        = STD:OBD

[emaflo1978]

with Ediabas (VCI ISTA) and 

Ediabas Ini
 INTERFACE     =STD:OBD

#INTERFACE       =REMOTE

the vehicle could not be identified