[fantomel]

OP-COM 2020 MULTI VERSIONS FREE 4 ALL


Please read before you respond in topic and please provide some feedback.



If you are curious open and see and you will not be sorry  I always keep my word.

And a little bit of help to see if your inteface is good or not.

+ I added down PDF's for CH-CAN modification and also if you like printed boards the project for it.

Enjoy

Fantomel

[fantomel]

Revision C can manualy diag CH-CAN modules IMU, SAS, SADS, EPS.


EPS - Elctronic Power Steering
IMU - Multi-Axis Acceleration Sensor Module
SAS - Steering Wheel Angle Sensor Module
SADS - Suspension Control Module

Cars with them:
Adam - EPS
Apera - IMU, SAS
Astra J - IMU, SAS, SADS
Cascada - IMU, SAS, SADS
Corsa E - EPS
Cruze - SAS
Karl/Viva - EPS
Mokka - IMU, SAS
Insignia - SAS, SADS
Zafira C - SAS, SADS

Since i forgot to add this info. You will not find them on autodetect but you can enter on them manualy.
Also because i was asked here is a real picture of a genuine V5 interface, not fakes.

[bigf7o]

Hy i have one op-com clone i have try all whit him buth dont i have connection whit auto only (please whait ,to the test interface is recognized and ok ...buth stil not work)there is a possibility to do something whit him ...... thank you very much

[mattydr67]

Hy i have one op-com clone i have try all whit him buth dont i have connection whit auto only (please whait ,to the test interface is recognized and ok ...buth stil not work)there is a possibility to do something whit him ...... thank you very much

You have  a fake MCU
In your PCB you have to remove C11 and replace the MCU with a real/original one and you have to flash it using an external PIC programming.
Check here
OP-COM v6 with "fake MCU" REPAIR (cartechnology.co.uk)

Good luck

[yayaasd]

wow - great work fantomel!!
I am just wondering if this PCB will work - see attachment

[bersch8688]

wow - great work fantomel!!
I am just wondering if this PCB will work - see attachment

Open your Eye's!
Check the Picture from Fantomel!!!

[yayaasd]

wow - great work fantomel!!
I am just wondering if this PCB will work - see attachment

Open your Eye's!
Check the Picture from Fantomel!!!

I did now again, thank you for clarifying.
seems that I have an fake pcb.

[justdiag]

As i remember in another forum a user put the PCB modification to revision C with BC847 and provided also the layout board (see attach)
And for this to be complete before the "reset" there was a modification done to OP-COM NEW PCB by a user who said that you need to cut a trace on the back of PCB then you need to to the same tutorial as the one for V5. (see picture bellow , don't mind the wire)




Keep in mind these infos are colected over time and i did not test them.

[justdiag]

Oups , clumsy me ...... i forgot about this one below , for those that are not in the mood of making one or don't find in china one good clone to modify and don't mind to spend 60$

i found this picture from a friend




And by looking around i found out that you can buy this interface in the link from attachment.



 case  

[mattydr67]

Just for your information:
This is the last 1:1 original OP-COM Advanced hardware Revision D+

Good luck