[ROD-BENDERS]

I tried the dpf off function on bmw e90 my 2008, edc17cp02 engine ecu. It disables dpf BUT only on tester an error appears which says that exhaust back pressure sensor value is outside tolerance. Tried to remove this DTC manually using Davinci but surprise : this dtc was already "removed" by the program. Car works but testing it gives you dtc

@Asztalos

1. I do not recall sending you a pass for my download and without a +rep from you I would not have sent you the password. Where did you get the pass ?

2. Make a seperate thread for this and post your file on it. 
3. Explain all the steps you have taken, for example, is the dpf removed from the exhaust ? Did you reset dpf with ori file before you write the file, were there any broken sensors etc but not here; do it  in a seperate thread.

RB

@asztalos 
I dealt with your last post a few months back.... next time you will get a warning.


Deja vu ?