[mcrussell]

[/quote]
I built my own mate.
[/quote]

No worries, only thing I can think is that the incorrect emulator cause the CP but didn’t show the error until after the update

[Pedrom92]

Hi guys,

I ordered an ENTRYNAV2 with MOST to replace mine for a 6WB retrofit on my wife’s F55.
I fitted it with an emulator so I could delete the FSCS & write the correct CPS vin.
This all went ok & managed to initialise component protection in ISTA, however my original FSCs would only load & not activate, failing with an FGN_CHECK_FAILURE even though both vin entries were correct.

I the flashed the unit up to the latest I level & tried to activate FSCs with the same error, I now have component protection active

Is there another vin position I have missed?

Can anyone supply the deblocking code to remove CP?

Any assistance is greatly appreciated

Regards
J

I had the same problem and I couldn't get it to work. 
 the unit was older than the new FSCs. 
I put virgin on the bench, changed the VIN, then put it in the car, coded and added the FSC and it always gave the same error. and I already had another one that replaced it with a unit with a wi-fi antenna and it was a simple process and it worked.

[mcrussell]

[/quote]

I had the same problem and I couldn't get it to work. 
 the unit was older than the new FSCs. 
I put virgin on the bench, changed the VIN, then put it in the car, coded and added the FSC and it always gave the same error. and I already had another one that replaced it with a unit with a wi-fi antenna and it was a simple process and it worked.
[/quote]

Thanks for the reply, did you manage to get round it at all?

[Pedrom92]

I don't know if the brand of the unit makes a difference or not.

[mcrussell]

I don't know if the brand of the unit makes a difference or not.

Did you have to buy another one?

[larshutten]

Problem is F56 firmware platform I think. Other firmware is usually not an issue but I also struggle with f56 platform…

Don’t know if the users succeed can confirm this is on F56 platform?

[alexnaoumov]

Problem is F56 firmware platform I think. Other firmware is usually not an issue but I also struggle with f56 platform…

Don’t know if the users succeed can confirm this is on F56 platform?

I changed one without problems, just how I described in my post. Enav2 needs to be virginised on table

[Pedrom92]

Problem is F56 firmware platform I think. Other firmware is usually not an issue but I also struggle with f56 platform…

Don’t know if the users succeed can confirm this is on F56 platform?

what didn't work for me was from a BMW F45 and I was putting it in an F30. 
 I ended up doing nothing on this car.

[sambir]

Can an entrynav2 be virginized on the bench? I heared you cannot fit a used entrynav2 in another car? The Entrynav2 you buy and fit in your car should be virgin/brand new...

[alexnaoumov]

Can an entrynav2 be virginized on the bench? I heared you cannot fit a used entrynav2 in another car? The Entrynav2 you buy and fit in your car should be virgin/brand new...

All info is posted two times by my and DayvG in this topic already how to clear entrynav2..