[egoy936]

Hello everyone,

I just retrofitted a NBT evo into my 2016 f10 with factory surround view. However sideview is not working shown in the photo below. I have confirmed 3AG and 5DL are part of the VO and factory coded it with this VO.


Suspect I need to FDL code something but I am unsure of what! Any help would be must appreciated.

[egoy936]

Bump?? Anyone have a f06 NBT EVO with surround view NCD file?

[maxwell4321]

Here you go but I have to ask have you checked the car with ISTA, it may just need camera calibration. Also VO code TRSVC.

[egoy936]

Here you go but I have to ask have you checked the car with ISTA, it may just need camera calibration. Also VO code TRSVC.

I tried all that and still will not work. I even tried a different TRVSC module. Same issue and the below error

800BA9 TRSVC CVBS Output, short circuit


Any ideas?

[DayvG]

Here you go but I have to ask have you checked the car with ISTA, it may just need camera calibration. Also VO code TRSVC.

I tried all that and still will not work. I even tried a different TRVSC module. Same issue and the below error

800BA9 TRSVC CVBS Output, short circuit


Any ideas?

Check your FBAS connection to the HU? Is it only top view cameras not working? Does rear cam work?

Attached is my CAFD from my F10 with NBT EVO including surround view.

[Jhnblckwood]

HU_NBT > 3001 > CAMERA_SYSTEM = trsvc

[ga3]

Is the HSD wire genuine?
If you use non-genuine HSD wire, the pin assignment may be different.
I recommend checking with a tester.

[egoy936]

Here you go but I have to ask have you checked the car with ISTA, it may just need camera calibration. Also VO code TRSVC.

I tried all that and still will not work. I even tried a different TRVSC module. Same issue and the below error

800BA9 TRSVC CVBS Output, short circuit


Any ideas?

Check your FBAS connection to the HU? Is it only top view cameras not working? Does rear cam work?

Attached is my CAFD from my F10 with NBT EVO including surround view.

Only Rear view camera works but still shows error on dash. Top view does not

---

Is the HSD wire genuine?
If you use non-genuine HSD wire, the pin assignment may be different.
I recommend checking with a tester.

I am using a quadlock harness with an activator. I wonder if this is the issue.

[ga3]

HSD wire is an LVDS 4-core wire between the camera and controller.

*edit
Oops, it was the factory 5DL...shouldn't be a problem just because I changed to EVO...

[maxwell4321]

The fact that your error says Short circuit points to incorrect wiring on your quadlock harness, check that the video cable pins from TRSVC are on 21(+),24 (-)and 23 (shield)at the EVO (could also be on pins 18(+) 28(-) 27(Shield).
Also you have to tell the EVO in the CAF which pins it is connected to, there is a werte value that needs setting. search caf for camera and find CAM ECU then set the werte value for Top/Side view to werte_01 (may need a different number if your video feed is on different pins)