[SergeusRUS]

Some can help with a calibration file.

I am looking for a parameter file for gateway with the number 4G8907468K for Audi a6 c7. 
Via online when replacing the gateway block, the parameters file did not load.
Thanks in advance

[PopDog]

For general it is very hard to find. If you have online access, to get a solution you can try a online software update. I don’t have a Service bulletin ready for it, but K must have firmware 0110 as in the flash data there is firmware 0113.

General SVM Update Codes at Audi for Gateway is 19A001,19A002 and try up till 19A008 or till it says unknown code. Hold file ready to place in Odis datflash folder, but don’t place it. If svm Code is not suitable for the gateway it will do nothing and tells you, that this code is not for the ecu. When you don’t place the flash file in datflash it tells you which file he wants and there you can see which file he wants to flash. When 0113 the place it in datflash folder and start flash.

When it works, they put parameters at the end. After that don’t close Odis, and don’t press anything, go directly in

C:\Program Files (x86)\Offboard_Diagnostic_Information_System_Service\configuration\org.eclipse.osgi\bundles\114\data\dms2\

or

C:\ProgramData\Offboard_Diagnostic_Information_System_Service\configuration\org.eclipse.osgi\bundles\114\data\dms2\

and there will be a xml file. Save this one and you also have parameters for next use on other car. Now you can press through till the end.

[SergeusRUS]

Yes, Gateway 4G8907468K has software with the number 0110. I tried with SVM code XCHG19A001. I will try with other codes. Thanks for the information.