Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Update Software unit control motor 651
29-03-2022, 19:40 PM,
Post: #1
|
|||
|
|||
Update Software unit control motor 651
Hello.
I need to update the engine control unit software of a Mercedes benz with monaco software. VIN: WDD2050041Rxxxxxx HW: 651 901 20 02 ZB: 651 902 28 03 SW: 651 903 40 66 Unit variant: CRD3S2_Diag_3146h Engine: 651 I can't find in the mercedes SD Flash disk which update corresponds to this unit. Please if someone can tell me best regards |
|||
30-03-2022, 07:59 AM,
Post: #2
|
|||
|
|||
RE: Update Software unit control motor 651
Why update needed?
-Pin for maps Ntg 4.5/5/5s1/5.5
-Comand region conversion -Remote coding/programming -Vediamo 5.1.1 passthru |
|||
30-03-2022, 08:35 AM,
Post: #3
|
|||
|
|||
RE: Update Software unit control motor 651
fault codes:
U029E87 Communication with NOx sensor 2 has a malfunction. Lack the message. Current and memorized 2. U029D87 Communication with NOx sensor 1 has malfunction. Lack the message. Current and memorized 3. P13DF09 The AdBlue system has a malfunction. There is a fault in the component. Current and memorized 4. P1BC300 Additional peripheral fault data for fault analysis (data record 03) Current and memorized 5. P229F09 NOx sensor 2 (cylinder bank 1) has a malfunction. There is a component failure. Current and memorized 6. P013511 Lambda probe heater 1 (cylinder bank 1) has an electrical fault. Exists a short to ground. memorized 7. P224392 Reference voltage connection of lambda probe 1 (cylinder bank 1) has an electrical fault or interruption. The function or indication is wrong. |
|||
30-03-2022, 11:01 AM,
Post: #4
|
|||
|
|||
RE: Update Software unit control motor 651
(30-03-2022, 08:35 AM)europhon Wrote: fault codes: No matter old or new firmware that should work and won't the cause of those faults. If you sure those sensors are good working, means that is hardware fail in ECU. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content