[egoy936]

Hello,

I have a 2013 f13 that I put a CAS back in with corrupt eeprom data after making a key. This took the car for a trip!! I was able to eventually write the original eeprom back to the CAS. I then managed to fix all error codes by clearing then factory coding FRM, ICM, CAS, KAFAS. I then followed ista to reinitiate any functions and set ride height.


Everything in the car working fine except the front collision system and I am left with these two codes. Also they will not clear and the test plans just say invalid signal:

E06C3C Signal (status, operating element brake assist, 0x31E) invalid, transmitter FEM/FRM/BDC-ZGM. Existent: Yes

D02D3A Signal (front area monitoring camera, 96.1.2) invalid, transmitter KAFAS. Existent: No


Also I should note these codes popped up the next day. The night I cleared all codes and factory coded the whole car was error free and a green tree in ISTA!

Any ideas what to check next??? Thank you in advanced!!

[egoy936]

Bump! Looking for some help

[egoy936]

Bump! Looking for some help

Bump again? I am thinking of just reflashing the FRM since it lost its coding data when putting in the corrupt eeprom! I had to inject cafd and factory code it that night.

[RuleNormaliai]

i would suggest to flash FRM, ICM, KAFAS and CAS to the same ilevel.