[pepi]

I need DPF off for Touareg EDC16 3.0

Thanks in advance

[gizmo220]

DPF off for Touareg EDC16 3.0

[pepi]

With DaVinci software not working , I have dtc software incompatibity with engine control module

[Leaking]

Disconnect diff pressure sensor

[loki954]

With DaVinci software not working , I have dtc software incompatibity with engine control module

with clone tool and obd read/write you will always have this dtc nothing to do with davinci. on this ecu is just a switch(1 bit) and dtc

[Elijah]

DPFoff, none of DTCs touched

Dissconect Difference pressure sensor and both EGTsensors, works 100%%

Password in PM

[pepi]

But this was BDM read not OBD , car still can not accelerate .
Can it be the wrong replacement ECU .
The original damaged was
7L0907401
0281011960
SW 1037383041
and this is
7L0907401B
0281012773
SW103738708
The car has taken off DPF and sensors, also there is DTC
012421 - Control Circuit for Intake Manifold Tuning (bank2)
P3085-001- Electrical Malfunction
Should I disable swirl flaps too ?

Elijah , I will try your file tomorrow when the car is here.

[Elijah]

Test my file, could try to disable additional DTC for swirl actuator and disconnect both swirl acuators, check swirl acutator wires next to plugs, had been few with crooked insulation and causing electrical errors..

As i understand you replaced ecu, looks like wrong hardware mate!!!
You donor - replacement one is
0281012773 7L0907401B BOSCH EDC 16CP34-4.9 VW (VOLKSWAGEN) Touareg 3.0 TDI (7LA) BKS

Your original damaged one is
0281011960 7L0907401 BOSCH EDC 16CP34-3.3 VW (VOLKSWAGEN) Touareg 3.0 TDI (7LA) BKS


Same engine codes but different hardware, one is EDC16CP34-3.3 the new one is EDC16CP34-4.9 i bet they are not interchangable


Dont forget to thank and leave rep if i helped !!!!