[aqeel2saf]

I have a ford transit with ecu sid208.
I used dpf delete software to delete the dpf. Got the dpf removed as well.
took all the dpf wires off.

1- The one just after turbo on exhause
2- one before dpf
3- one after dpf
4- the on dpf injection pump( used for regen)

now problem is vehicle goes into limp mode after driving it for few seconds. but there is no lights on dash.
while its running if i quckly switch it off and on again it works fine for few minutes and goes into limp mode again. ( less power, little pickup. about 70%  only)

today when it went for mot it failed on smoke. so i told the mot tester to restart the van. when he restarted and tested it passed.

so the limp mode is also causing heavy smoke.

please help.

i have attached orignal ecu file and dpf delete file. please check if you can remove the limp mode entirely from ecu.

many thanks

[moriaz]

what software did you use to do the delete

[EuroCSL]

thanks rep pm for pass test and report, comparing my file and yours it looks like your software did not remove it

[aqeel2saf]

what software did you use to do the delete

i got it from this website

DPF Remover 2017.05

---

thanks rep pm for pass test and report, comparing my file and yours it looks like your software did not remove it

thank you for helping. I will try the file tomorrow and update you. many thanks again

[aqeel2saf]

thanks rep pm for pass test and report, comparing my file and yours it looks like your software did not remove it

can you please redo the file. as previously i had sent you the non patched version. (ktag)

[EuroCSL]

thanks rep pm for pass test and report.

[aqeel2saf]

thanks rep pm for pass test and report.

hiya thanks for the fix.

the vehicle is running super good now.
but i get engine light on on dash.
with diagnostic it says 
air flow too high

can you please check
thanks

[BPCD]

thanks rep pm for pass test and report.

hiya thanks for the fix.

the vehicle is running super good now.
but i get engine light on on dash.
with diagnostic it says 
air flow too high

can you please check
thanks

Hello,

here the file with DPF-OFF

Pass in PM

Test let let know the result

Regards Marco

[aqeel2saf]

thank you guys for all the help. the vehicle is working perfect