[autogaskomotini]

Hi to all. I am struggling with immo off for a mss50 ..
bmw e36 m3
ecu is : siemens 5wk9 025 dme mss50 1 403 700
i read the right (2) flash in the picture that i am attaching with programmer as [email protected]
is this the right flash to read for immo off or i have to read the other flash ?
and for tuning maps which flash i have to read ?
I am attaching the picture of the flash that i read ( flash 2 marked in the picture) with the ori file.
Can someone help me with immo off please ?
Thank you all..

[AZCKNCLLC]

Hi to all. I am struggling with immo off for a mss50 ..
bmw e36 m3
ecu is : siemens 5wk9 025 dme mss50 1 403 700
i read the right (2) flash in the picture that i am attaching with programmer as [email protected]
is this the right flash to read for immo off or i have to read the other flash ?
and for tuning maps which flash i have to read ?
I am attaching the picture of the flash that i read ( flash 2 marked in the picture) with the ori file.
Can someone help me with immo off please ?
Thank you all..

try read 32kb partial and post here.

[autogaskomotini]

i have only the ecu. tried to read on bench without soldering but without success . So my only chance is to desolder and read with programmer . I read one flash . the one on the right in the picture. is this enough or do i have to read to read the other flash too ?

[EuroCSL]

Immo is on the left flash

[AZCKNCLLC]

i have only the ecu. tried to read on bench without soldering but without success . So my only chance  is to desolder and read with programmer . I read one flash . the one on the right in the picture. is this enough or do i have to read to read the other flash too ?

where is reading from other flash?

[autogaskomotini]

i have only the ecu. tried to read on bench without soldering but without success . So my only chance  is to desolder and read with programmer . I read one flash . the one on the right in the picture. is this enough or do i have to read to read the other flash too ?

where is reading from other flash?

here are tthe two flashes read seperately by removing with programmer. every time i read i was getting different values. i dont know if i read them right..
 Edit: i wrote wrong the file names. right is left and left is right socket looking towards to me

---

Also i reead something about swap to big endian . i just read the flash. do i have to convert them to big endian know? I dont know how to convert to big endian .