[sabinglig]

if you click on "STATUS_VCM_GET_ECU_LIST_FLEXRAY" do you get SAS on the list?

[mr_nitroz]

No, here is my actual flexray channel overview and flexray VCM read.

---

If I use function STEUERN_DIAG_PLUS_FLEXRAY I get PFAD 3 open with other channels but no difference...

[mr_nitroz]

PROBLEM SOLVED!!!!

Thanks everybody for great informations and help.

The magic think I had to make is write SVT target with manually added SAS via VCM, as sguzzel wrote in first post. I was doing it bad way as I was operating with SVT actual (ist) and not SVT target (soll). I learned a lot from this issue. Hope it will help to someone else too.

After that SAS appeared in unit list and it was a peace of cake then... I coded it successfully, updated SAS to car´s i-level, initialisated flexray via tool32, deleted all errors and went for a test drive.