Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Problem F48 with Esys flashing now no KL15
26-08-2022, 13:06 PM,
Post: #31
|
|||
|
|||
RE: Problem F48 with Esys flashing now no KL15
You don't need similar. You need this vehicle. SVT is stored in two units in the vehicle. BDC is master and there is a backup (don't remember which one). So there is a good chance backup is still there. Or else you can write new SVT calculated by ESys.
|
|||
26-08-2022, 13:07 PM,
Post: #32
|
|||
|
|||
RE: Problem F48 with Esys flashing now no KL15
Yes you can, of course check that bdc matches your car equipment.. this can be done via esys.
Copy FA SVT. And most important thing... change isn |
|||
26-08-2022, 13:09 PM,
Post: #33
|
|||
|
|||
RE: Problem F48 with Esys flashing now no KL15
I don't have ESys now so can't tell how to do that exactly.
|
|||
26-08-2022, 16:16 PM,
Post: #34
|
|||
|
|||
RE: Problem F48 with Esys flashing now no KL15
So now I'm by ESys. This is how you do that.
1. Establish connection. 2. Go to Expert mode/VCM. 3. Select backup tab in the bottom. 4. Click read data in VCM backup group. 5. Optionally go to File and save FA just read. 6. Review FA/iSteps to be correct. If ok continue, if backup is also broken, load your FA file. 7. Click Restore data. 8. In vehicle order right click on "FA" and click calculate FP. 9. Go to master tab. 10. Click write FA FP. Now I don't remember exactly what to do with SVT and don't have any F series car to try now. But I think it should be like this: 11. In file tab load svt_target_custom.xml file as SVT target. 12. In master tab click Write SVT. I also provide you a custom tal file to fully reflash BDC, ACSM and other units (starting from the latest SVT actual you provided in this thread). P.S. This really assumes you fixed ISN which is doable with neither ESys nor ISTA. |