[Valery63]

Hi.
Please help to reset the hours of operation in the firmware of the unit.
Control unit d60m57a0.
In EEPROM I changed the coding lines to Mil-off, but there is still an error on the particulate filter and pressure sensors.
I'm trying to make a mode without a particulate filter by the factory method.
Attached FULL-Flash and EEPROM

[Valery63]

Any clue. What needs to be done?

[____ANGEL___]

yes, don't touch anyting anywere, leave all original, and flash correct software. Is CT96422 your correct vin?

[Valery63]

Vin is correct. Only cells with encoding data have been corrected.
Disabled temperature and back pressure sensors. After that, a complete flashing of the block. But as a result, an error on disabled sensors.
Throttle plug did not turn off. But judging by the ETC in my version, it should be.
What else did you forget to do to switch to work without a particulate filter?

"leave all original" Or do you mean that the sensors do not need to be disconnected?
But if you look at the ETK, then in the version without a particulate filter they are not.

[____ANGEL___]

please send me you ori eeprom and flash

[Valery63]

Original EEEPROM and FLASH