[BimmerSLO]

Hello

I am having issues activating a used DSC module on a 2006 M6. I winkfp flashed, ncs coded and initialized steering angle sensor. The only two faults I have are 5DD0 and 5DD2 for inlet and outlet ABS DSC valve calibration. 

The problem is when I make the DSC valve calibration with ISTA, it successfully calibrates the pressure sensors but always fails to calibrate the valves. 

Any help please?

---

CBS are all reset to initial mileage.

[danis11]

The calibration kept failing because it was obviously loosing pressure during the test. Leak or air in the system.

[bmchicago]

this fault usually caused by wrong VIN in DSC or mismatch. check UIF for VIN, use Tool32 to write VIN

[pereq]

As above tool32 to put your VIN and after that you'll be able to finish job