[ricarpa]

Hello everyone. Does anyone know if independent modules of our bmw can be programmed-updated with ista d as with ista p in expert mode? Formerly with ista p in bmw you could choose a module and encode it or update it. Now with this view it is not possible. If we have a module that is retrofitted, we must remove it to update all the modules as a whole. Do you know if there is any other way? Thank you

[Bagum4uk]

You should use Esys , if you want to update few modules only! In Ista only possible to update whole car, there’s no option to update only one module

[aspy39]

ista d is good for what its used for, but its restricted and will only do what is required ie program all modules, there are other softwares that can do what u want such as esys, vvdibmw, autohex etc

[florinu]

you can update it with ISTA P only one module , but exist some condition when one module update depending by another module update .

[dwmotorworks]

Miss read the post.. apologies.. ista d doesn’t have an individual programming/coding option esys is required for this on later cars

[plamen_n]

Miss read the post.. apologies..  ista d doesn’t have an individual programming/coding option esys is required for this on later cars

Disagreee... Its tricky but is possible via ISTA - P Expert mode.Just click in the disired module and select programing/coding.Must know cause when system create measures plan can add other modules depending ot selected for programming

[mjuhl2003]

We are talking ista-d not P

[plamen_n]

We are talking ista-d not P

Sorry - my mistake But also is possiblle - if module I-level is the same or lower - Happenind to me yesterday on a old F11 - I flash just Stering column module (because of stering angle sensor was brought second hand from car morgue)