[russell]

i have a st diesel with
p2463 soot accumulation fault active
p253f oil deteroition signalshape/waveform failure active
p244c catalyst temp too low during regen bank 1-signal to high pending
i have tried to force regen with delphi and forscan but both fail within 2 seconds
i dont think filter is blocked as i only get 2psi of pressure @2500rpm


i suspect the map has been altered
would some one be able to check or advise where to go next
may thanks

[jurscam]

i have a st diesel with
p2463 soot accumulation fault active
p253f oil deteroition signalshape/waveform failure active
p244c catalyst temp too low during regen bank 1-signal to high pending
i have tried to force regen with delphi and forscan but both fail within 2 seconds
i dont think filter is blocked as i only get 2psi of pressure @2500rpm


i suspect the map has been altered
would some one be able to check or advise where to go next
may thanks

You need replacing the injector before the particulate filter, and than you can done regeration. Or cut out particale filter and than program dpf off

[russell]

i have a st diesel with
p2463 soot accumulation fault active
p253f oil deteroition signalshape/waveform failure active
p244c catalyst temp too low during regen bank 1-signal to high pending
i have tried to force regen with delphi and forscan but both fail within 2 seconds
i dont think filter is blocked as i only get 2psi of pressure @2500rpm


i suspect the map has been altered
would some one be able to check or advise where to go next
may thanks

You need replacing the injector before the particulate filter, and than you can done regeration. Or cut out particale filter and than program dpf off