Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
206 Jaeger vs Xprog 5.51 and Digiprog 3 [ Solved ]
23-05-2015, 19:15 PM,
(This post was last modified: 26-05-2015, 21:50 PM by volavka.)
Post: #1
|
|||
|
|||
206 Jaeger vs Xprog 5.51 and Digiprog 3 [ Solved ]
Hi to all!
First, I want to clarify that is the first time I´m using X-prog 5.51 and first time Digiprog 4.94, both chinese clones. I want to read the MC68HC(7)05H12 with mask 0H57A but tried with both with NO success. What I did was: XPROG 1 - connected X-prog according with attached scheme. 2 - tried with and without 12v on xprog 3 - changed USB cable and FTDI driver. Change from COM5 to COM2. Result: Always get error DEVICE IS SILENT DIGIPROG 1 - Since I don´t have the ST 28 adapter I´ve used the pinout on the web: ST 28 AMP-929650-2 yellow 9 yellow green 10 green brown 13 11 white 20 white yellow 25 10 white 25 5 IF SOMEONE HAS THIS ADAPTER (28), CAN CONFIRM CONNECTIONS PLEASE? 2 - I used the scheme as attached PDF. Result: READ ERROR NYO4 says: POWER pin 5 is VCC 12v pin 11 is GND Should I have to feed direct 12v to AMP plug on cluster ??? Thanks in advance for helping me on this quest Smile UPDATE: I´ve tried to power cluster with 12v and read with xprog but result is the same: DEVICE IS SILENT. |