[jimvou]

I have ISTA/P 3.55.4.000 using Loader v 3.2 for ICOM Emulator.

I have set it all up correctly, used the Network Tool. When I try to connect it shows up ZGW and I input this, When ISTA/P opens up and I click create new session it comes up with server error. I have tried to connect to server automatically and manually. But will not connect.


Error is  : -

" NO ISTA/P Server on which a session can be started was found. Try again later. "


Anyone had this before ?.

I had the same problem on my Windows 10 and I solved it when I made settings reset on ISTA P Loader

[tomaxsas]

Same issue on two computers. Installed fresh Win 10 on third and it works, any suggestions? tried disabling firewall, reseting launcher, disabling AV did not helped.

[bmchicago]

try using ISTA/D 4.37.xx for F+ vehicles, and ISTA/P 3.70.xx for E series. No longer use this old software

[tomaxsas]

i'm using ISTA/P 3.70 but i have issues same as OP, using loader 6.6l

[Node]

Is your computer fast? Like with plenty of RAM and SSD. I have ISTA/P on my very old computer only (with HDD and 4GB RAM only) just in case I ever will need it. I need to allow for plenty of time for it to start up.

Even after GUI is shown where you can start creating sessions if I do that immediately - session creation fails and that's it. Need to shutdown ISTA and loader for another try.

In order to create a session, I usually leave computer to load ISTA properly for like 5 minutes AFTER GUI is shown. Then I can create sessions and work.

[tomaxsas]

yes, my computer is pretty fast, like twice as fast as my old, on which i installed fresh win 10 and istap, and on it it works fine. i'll try to leave it open for longer