[dankocg]

i fix and done but now odometar dont write km the speed is measured as well as the rpm, but the mileage does not work...Can you check this eprom?

if anyone is interested in how I did it, here are the steps:

1- set cluster to newmode with vag eeprom commander

2- connect to instruments with vcds, adaptation-10, channel 50. enter ECU pin 01396

3- turn ignition off and remove the key about 1 minute

4- turn ignition on, connect to instruments with vcds, measuring block 22 and see key status.

5- also see measuring block 24 and wait until fields 1, 2 and 3 reach 0 - this is minutes. when this fields reach 0 minutes, the field 3 of measuring block 22 comes to 1 - key can be adapted.

6- do login with ECU's login (01396)

7- open adaptation-10 and go to channel 21. in new value type the number of keys to adapt, in my case there is only one.

8- test and save, close controller

here is eprom data from cluster.