[kimz]

Hi,
is it possible to read errors with a description from total diagnostic -> read error memory from all ecus?

[Node]

Don't think so as fault descriptions are in respective prgs. Which are not loaded when reading fault from whole car. And same fault code can mean VERY different faults in different units.

[kimz]

I see, it makes sense

[Node]

Just as an example from your fault list:

Fault code - unit - description
0x009C69 automatic heating and air conditioning (ihka60_2) IHKA: Monitor, supply, compressor clutch BASIS
0x009C69 Automatic heating/air conditioning (ihka60) IHKA: Rear compartment stratification controller
0x009C69 Automatic heating/air conditioning (ihka65) IHKA: Air volume (high left)
0x009C69 Automatic heating/air conditioning (ihka70) Module PTC
0x009C69 Automatic heating/air conditioning (ihkarr) IHKA: Current consumption, refrigerant compressor
0x009C69 Junction Box electronics (jbbf70) JBE: Rear-cabin stratification adjuster
0x009C69 Junction Box electronics (jbbf87) JBE: Rear stratification-flap potentiometer

[Vojno]

This inpa windows is not what you expect it to be!
I understand what you want, but.....
You should know what this program is for and who uses it!

This is a developer tool, it shouldn't have been leaked!
Be happy how it is, or else you have to buy a serious paid program, which may have expectations!

[Enabled]

If you do a vehicle check in, it will read everything and give you a long long list of all the data. Typically this is for engineering use only. It takes a while.

It's easier to just enter the modules one by one and read errors.

I only use that menu for a quick clear of everything after flashing or other work.