[miguelsilv6]

BERLINGO - BSI JCI 83.8E VIRGIN FLASH

Hello friends,

I have a Friend use FVDI, and kill BSI

I write a virgin FLASH and engine not start.

Need virgin EEPROM?

Dash light on, engine not start

Any help?
 
BSI JCI 83.8E VIRGIN

  --- electronic control unit identification ---

Functional Plan No:            9664058780
Manufacturer:                  Johnson Controls
Functional Product No:        9666895580
Software Index:                05.02
Calibration Index:            00.00
Diagnostic Index:              OR
Serial Number:                012809
Manufactoring Date:            10/8/2030
System:                        B0
Software edition:              16.32
Software signature:            83.8E
Software reference:            9675689780
Manufactoring Date2:          1D/8/2010
Programming Date:              16/9/2029

Thanks

[nikosmb]

I don't think you can get a job.
a few days ago, a similar vehicle came to me with the same damage,
I tried it a lot but it didn't work, I bought a used one and adapted it to the vehicle

[miguelsilv6]

I don't think you can get a job.
a few days ago, a similar vehicle came to me with the same damage,
I tried it a lot but it didn't work, I bought a used one and adapted it to the vehicle

How can I adapt to the vehicle? I have several used BSI

[asto]

Hi
must virginized eep in used bsi and after use diagbox or pps2000 and configure car,add keys with pincode from your car,pls if help u use magics buttons


BR ato

[miguelsilv6]

Hi
must virginized eep in used bsi and after use diagbox or pps2000 and configure car,add keys with pincode from your car,pls if help u use magics buttons


BR ato

can i use the old keys? Is there a way to program the old keys into the virgin EEPROM?

Thanks

[nikosmb]

the procedure is very simple. it doesn't need a virgin eeprom, it just needs the pin code of the bsi and the pin code of the car to make the adjustment. and then the old keys are programmed.

[miguelsilv6]

the procedure is very simple. it doesn't need a virgin eeprom, it just needs the pin code of the bsi and the pin code of the car to make the adjustment. and then the old keys are programmed.

The EEPROM I have is damaged.

I'll have to put virgin. How do I do it in this case without a PIN?

Or how do I put the ECU PIN into the BSI EEPROM?

Thanks

[miguelsilv6]

Now have tis error in BSI and car not start

Functional Plan No: 9664058780
Manufacturer: Johnson Controls
Functional Product No: 9666895580
Software Index: 05.02
Diagnostic Index: X
System: B0
Software edition: 16.32
Software signature: 83.8E
Software reference: 9675689780
Manufactoring Date2: 1D/0/2010
Programming Date: 16/9/2029
VIN: VF77B9HTCAJ822905
Engine type: Unknown


--- read diagnostic trouble codes ---

===
UNKNOWN DTC: B403
===
UNKNOWN DTC: F4BA
===
UNKNOWN DTC: A4D3
===
UNKNOWN DTC: A4D4
===
UNKNOWN DTC: F303
===
Total: 5 DTCs found