[al70]

The van is running without the cluster, tomorrow I will try forscan , cheers

[al70]

Hi all, I'm back to this transit again, the guy got a cluster from another transit, this cluster is different, it has the smaller display in the middle, installed the cluster and everything is fine except mileage is too low, so he raised the mileage, mileage correction is ok but when he drives the van for a mile or so the mileage disappears and just dash's show on display, any ideas how to solve this ? Cheers
update
this is a pic of the tool he read the cluster with, i don't know if it makes any sense its 8kb file, could someone have a look at the file and see if mileage is visible

[iProg-carradio]

this is a pic of the tool he read the cluster with, i don't know if it makes any sense its 8kb file, could someone have a look at the file and see if mileage is visible

in bencustom.zip - distance = 28511 km

Good luck.

[al70]

Ok, when the guy raises the mileage, it shows dash's **** after a short journey, I was thinking maybe it was checksum problem, could someone change the mileage to 95000 miles and if needed correct the checksums, cheers.