Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Meriva 2009 Z17DT - OP-Com china clone FW 1.45 08-2010
12-06-2015, 22:00 PM,
Post: #1
|
|||
|
|||
Meriva 2009 Z17DT - OP-Com china clone FW 1.45 08-2010
Hi guys, I've got a Meriva 2009 Z17DT.
Since last week I'm getting error P242F-06 (DPF sensor). After some research I've found a defect cable of the DPF temperature sensor and fixed it. But the error still occures periodically. I've ordered a china OP-COM clone in order to initialize a manual DPF regeneration. It was shipped with 08-2010. Installation was fine, drivers are working. A first try on the obd was successful. I noticed, that the 08-2010 has trouble to recognize my Z17DT automatically. If I select it manually, it only supports failure read and reset. After that I tried the op-com 120309a(FW 1.45). Adapter is recognized, test is fine, but auto recognization fails. Special features are disabled. After some research I've found out, that there are several OP-Com versions. Meriva is supported by OP-COM Basic-C. Do I need 120309c to solve my problem? Does anyone have the same problem and perhaps a solution? |
|||
17-06-2015, 17:53 PM,
Post: #2
|
|||
|
|||
RE: Meriva 2009 Z17DT - OP-Com china clone FW 1.45 08-2010
Ha, you want to use official software on a chinese clone? Don't think so. If that option is not in the 12309a, bad luck.
|
|||
18-06-2015, 05:38 AM,
Post: #3
|
|||
|
|||
RE: Meriva 2009 Z17DT - OP-Com china clone FW 1.45 08-2010
Logically if you fixed the cable of the DPF temperature senzor was defective now the next steps is to change the senzor itself
A shortcut can damage the senzor too About your opcom clone you need to use newer softwares.( 120309a is old and has no many updates. Newer can or cannot have too many upgrades for that ecu ) Good luck |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content