[jpbroad1970]

Hi, does anyone have access to the official etka, I need a copy of the reverse camera template that is linked to from the rear bumper. It can only be got through etka apparently. Although I have access to the parts catalogue I can't get any links.


You help is much appreciated

[oscar89]

For those parts, you need to look in Elsa and lookup on repair manual. At the top of the page it lists all the needed equipment with part numbers

PS: the reverse camera calibration board is a part of the ADAS calibration set which is expensive. A better alternative is to buy a copied calibration sheet from aliexpress which works perfectly when setup correctly

[jpbroad1970]

Thanks, I couldn't get my highline camera to work so still using a lowline one

[Reddstripe79]

I looked everywhere for the template (ETKA; Infoline brochure no. SEAT 807) but couldn’t find it. In the end I took the bumper off and measured up the from the back side of the bumper using the number plate light holes to pinpoint the centre. Then positioned and marked around the camera holder opening to get it centralised between the reveal. From memory it was ever so slightly larger that the holder for the camera itself but it’s easier to start small and take more off as you go.

[david99]

I think it should be the file in attachment right? This pattern is for rear camera calibration. You could get it printed in advertisement company or professional print studio. I did it like that.

[jpbroad1970]

I'm pretty sure my camera is faulty as I've tried fitting it 10 times and cannot get the can gateway to see it. Unless I've missed something in coding but it all seems pretty straight forward.