[skyrimzz]

hello guys,i have a problem with astra g 1.8 automatic,simtec70..we swaped ecu ,it has same numbers and car started but this car is automatic and donor ecu is from car with manual gearbox..swap of ecus was made with pins ,needed only new key transponder..this car doesnt have program variant,so i cant ecu options for gearbox,climate..what else can i do?if i try to clone eeprom with car prog will it copy also configuration?where is the configuration of ecu located?in flash or eeprom?thanks in advance

[victorysatgr]

i think you must clone flash, the driving maps are there..... Or make sps according vin..........

[skyrimzz]

thanks for infowhat tool to clone flash from that ecu?what is the easiest way to adopt configuration of that ecu?i just saw that kess clone has that ecu..if i write map from ori ecu will it copy configuration also then?thanks in advance

[skyrimzz]

carprog used for reading pin from both ecus..opcom for swap ecu and then added keys if needed..only problem i had ecu was for manual gearbox and i had automatic gearbox.tred to flash eeprom with carprog and it was all ok until u turned ingition off..on ignition on settings were back to default..manual gearbox etc..